ADO Seek Method
Complete Recordset Object Reference
The Seek method searches the index of a Recordset to find a record that matches
the values specified in the keyvalues parameter. If there is a match, the pointer will point to
the record specified by the seekoption parameter. If there is no match, the record pointer will be placed at the end of the
Recordset.
Note: To use this method, the provider must support this method and the use of indexes on
a Recordset (the Index property). Use the Supports method to determine whether the
provider supports seek and indexes.
Note: Set the Index property to the desired index before executing this method.
Note: This method can only be used with server-side cursors (not supported when the
CursorLocation property value is adUseClient).
Note: This method can only be used when the Recordset object was opened with
the CommandTypeEnum value of adCmdTableDirect.
Syntax
recordsetobj.Seek keyvalues,seekoption
|
Parameter |
Description |
keyvalues |
Required. An array of values to compare with the values
in each column |
seekoption |
Required. A SeekEnum value that
specifies the type of seek |
SeekEnum Values
Constant |
Value |
Description |
adSeekFirstEQ |
1 |
Seeks the first key equal to keyvalues |
adSeekLastEQ |
2 |
Seeks the last key equal to keyvalues |
adSeekAfterEQ |
4 |
Seeks either a key equal to keyvalues or just
after where that match would have occurred |
adSeekAfter |
8 |
Seeks a key just after where a match with keyvalues would
have occurred |
adSeekBeforeEQ |
16 |
Seeks either a key equal to keyvalues or
just before where that match would have occurred |
adSeekBefore |
32 |
Seeks a key just before where a match with keyvalues would
have occurred |
Complete Recordset Object Reference
…
|